LED action Projector state Description
Flashing red New critical alarm or warning New critical alarm or warning has
not been acknowledged b
y the
operator.
Solid red Existing critical alarm or warning Critical alarm or warning exists, but
has been acknowledged by the
operator.
Logging into the projector
Log into the projector to access projector menus.
1.
Select Login.
2. In the User list, select a user name.
3. Enter your password.
4. Select Login.
Logging out of the projector
Log out of the projector to restrict access to projector menus or to change access permissions.
• Select Logout.
Determining the projector IP address
Before accessing the projector user interface remotely, determine the IP address of the projector. Use
the following method to determine the projector IP address when no touch panel is installed.
1. Connect the projector to the theater network using an Ethernet cable.
2. Make sure the projector is not in Standby mode by selecting the recessed button between the
USB-C port and the USB port on the Video Input panel.
Selecting the recessed button transitions the projector from Standby to powered on.
Operating the projector
CineLife+ User Guide 16
020-103073-10 R
ev. 1 (02-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
To Next Page
Loading...
