Action item Available actions Description
On
Light
Off
Turns the light off.
Standby Puts the projector in standby mode.
Channel Selects a specific projector channel.
Revert Warp File Reverts the active warp file to its previous settings.
Full Power Places the projector in full power mode.
Wait Delays the execution of a macro.
Fire alarm macro
By default, the projector is configured with a macro using a building fire alarm as the trigger
.
If the projector is connected the building's fire alarm system (recommended installation), the default
FIRE_ALARM macro puts the projector into Standby mode if a fire alarm occurs.
You can also create a custom macro that uses the fire alarm trigger or edit the default fire alarm
macro to perform other actions as needed.
Christie ACT actions
The following built-in commands are available for Christie ACT.
Command Description
Buzzer Activates the buzzer for the specified time (in milliseconds).
Button Simulates pressing or holding the ACT button.
Pulse Relay Sends a pulse to a specific relay.
Open Relay Opens a specific relay.
Close Relay Closes a specific relay.
Pulse GPO Sends a pulse to a specific GPO pin.
Set All GPOs Sets the values for all GPO pins.
Run Script Runs a script on the Christie ACT.
Flash LED Causes a specific LED to flash.
Set All LEDs Sets values for all of the LEDs.
Automation
CineLife+ User Guide 95
020-103073-10 R
ev. 1 (02-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
To Next Page
Loading...
