5. Complete the Trap Receiver IP fields.
A tr
ap receiver captures, displays, and logs SNMP traps. Traps are event notices sent
immediately to the trap receiver from a network device. The SNMP device does not need to use
resources to poll for these event notices.
6. In the Blocked SNMP Traps area, select the SNMP traps you want to block.
7. Select Save.
Downloading MIB information
A Management Information Base (MIB) file contains the definitions for the device being managed by
the SNMP protocol.
1. In the left navigation menu, select Service Setup > Network Settings.
2. Select the SNMP tab.
3. Select Download MIB.
4. Browse to the location where you want to save the MIB file.
5. In the Name field, enter a name for the MIB file.
6. Select Accept.
7. Select OK.
Network settings
CineLife+ User Guide 65
020-103073-10 R
ev. 1 (02-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
To Next Page
Loading...
