Chroma 19020 - Setting SYSTEM CONFIG

Multi-Channel Sync Hipot Tester 19020/19020-4/19021/19021-4/19022/19022-4
User’s Manual
4-10
4.4.3 Setting SYSTEM CONFIG
In SYSTEM screen, move the highlight to SYSYEM CONFIG and ENTER to go to SYSYEM
CONFIG setting screen as shown below:
SYSTEM CONFIG
01.
CONTRAST :
06
UP
02.
BEEPER :
LOW
03.
GPIB :
UNINSTALLED
DOWN
04.
RS232 :
9600
05.
LINK SETUP :
MASTER
06.
LINK ADDRESS :
0
07.
ACA MEAS. :
RMS
08.
DC ARC RATE :
1.0
EXIT
1-16
REMOTE
LOCK
OFFSET
ERROR
When in SYSTEM CONFIG screen, press ▲, ▼ to move the highlight to the item desired for
setting the related function.
The following table lists the setting items of SYSYTEM CONFIG and their descriptions.
Setting Items
Range
Default
Description
CONTRAST
1 - 16
06
It adjusts the LCD brightness.
BEEPER
HIGH / LOW / OFF
LOW
It adjusts the beeper volume.
GPIB
UNINSTALLED /
ADDRESS = 0~30
03
It sets the GPIB interface address. It
shows UNINSTALLED if GPIB card is
not installed.
RS232
9600 / 19200 / 38400
9600
It sets the transmission baud rate of
RS232 interface.
LINK SETUP
MASTER/SLAVE/SCA
NNER
MASTER
It sets the tester to be MASTER or
SLAVE when linked for test.
Be sure to set it to SCANNER when
connecting to A190201/A190202.
LINK ADDRESS
1~9
0
It sets the tester address when linked
for test.
Note: The tester address is fixed to 0
when set to MASTER.
ACA MEAS
RMS/GENERAL
RMS
It sets the AC current measurement.
DC ARC RATE
1.0~10.0
1.0
The ARC LIMIT setting will multiply this
rate for RAMP, DWELL time during DC
MODE test.
1. When LINK SETUP is set to SLAVE, besides the items “02.
SYSTEM CONFIG”, “05. CHANGE PASSWORD”, “06.
CALIBRATION”, “07. ERROR LOG” and “08. ABOUT” in the
SYSTEM screen, the rest items are all invalid.
2. Only the 19020/19020-04 LINK SETUP settings has SCANNER
selection.