To Next Page

To Previous Page

Operation

4-13

Enter the PASSWORD and press ENTER, the LOCK box returns to normal indicating the

FAIL LOCK is cancelled.

4.4.6 Changing PASSWORD

Setting password for KEY LOCK:

In SYSTEM screen, move the highlight to CHANGE PASSWORD and press ENTER to go to

CHANGE PASSWORD setting screen as shown below:

1. Enter the PASSWORD (enter 0000 if it hasn’t been set) and press ENTER will prompt a

“NEW PASSWORD” window.

2. Enter the NEW PASSWORD (maximum 10 characters) and press ENTER will prompt a

“CONFIRM PASSWORD” window.

3. Enter the same password again and press ENTER. A message “CHANGE PASSWORD

OK!” will appear to indicate the password has been changed. Press Function Key [EXIT]

to quit the Setting Screen.

If the memory has been cleared following the description of “Clear the

settings and test procedures in memory” in section 4.4.7, the

PASSWORD will return to initial that is 0000.

FAIL LOCK

UNLOCK:

USER PASSWORD:■

EXIT

REMOTE

LOCK

CORR

ERROR

CHANGE PASSWORD