Chroma 19020 - Page 46

Multi-Channel Sync Hipot Tester 19020/19020-4/19021/19021-4/19022/19022-4
User’s Manual
4-20
[OFFSET] first to conduct OFFSET. OFFSET needs to be done
every time the cable or fixture is changed to ensure the test
accuracy.
3. When conducting tests in OSC Mode, the test condition for judging
OPEN/SHORT is the reading of GET Cs.
4. Please follow the model to set the output channel, for instance, the
19020 can set the output channel to CH1~CH10 while the 19020-4
can only set the channel to CH1~CH4. The message line on the test
screen will show “Module Fail” if set otherwise and the test is unable
to start.
Pause Mode (PA) (for Model 19020/19020-4/19021/19021-4/19022/19022-4)
PROGRAM
01.
TEST STEP :
1
AC
02.
TEST MODE :
PA
03.
MESSAGE :
PAUSE-MODE
DC
04.
TIME :
CONTINUE
IR
OSC
PA
EXIT
SELECT MODE
REMOTE
LOCK
CORR
ERROR
MESSAGE : It sets the message for pause screen, maximum 13 characters for input.
TIME : It sets the action of PAUSE MODE.
(1) CONTINUE : The pause mode only ends when START on the
panel is pressed or START signal on the HANDLER
card is triggered again.
(2) 0.1~999.9sec : The pause mode ends when it reaches the time set.