Chroma 63600 Series - Page 172

Programmable DC Electronic Load 63600 Series Operation & Programming Manual
5-40
:CONFigure :DIO :IN1
:IN2
:OUT2
:VOLTage
SP
?
<NR
1
>
SP
?
SP
?
SP
?
<NR1>
<NR1>
<NR1>
<NR1>
<NR1>
<NR1>
<NR1>
:OUT1
SP
?
<NR1>
<
NR1>
CONFigure:ALLRun
Type: Channel-Specific
Description: Set the load module all run state.
Setting Syntax: CONFigure:ALLRun<space><CRD | NR1>
Setting Parameters:<CRD | NR1>, OFF(0), ON(1)
Setting Example: CONF:ALLR ON Set all run state to ON.
CONF:ALLR 0 Set all run state to OFF.
Query Syntax: CONFigure:ALLRun?
Return Parameters:<CRD>, OFF, ON [Unit = None]
Query Example: CONF:ALLRun?
CONFigure:AUTO:ON
Type: Channel-Specific
Description: Set the load module to perform auto load on during power-on.
Setting Syntax: CONFigure:AUTO:ON<space><CRD | NR1>
Setting Parameters:<CRD | NR1>, OFF(0), ON(1)
Setting Example: CONF:AUTO:ON ON Set auto load on state to ON.
CONF:AUTO:ON 0 Set auto load on state to OFF.
Query Syntax: CONFigure:AUTO:ON?
Return Parameters:<CRD>, OFF, ON [Unit = None]
Query Example: CONF:AUTO:ON?
CONFigure:EXTernal:WAVeform
Type: Channel-Specific
Description: Set the external waveform function on/off.
Setting Syntax: CONFigure:EXTernal:WAVeform<space><CRD | NR1>
Setting Parameters:<CRD | NR1>, OFF(0), ON(1)
Setting Example: CONF:EXT:WAV ON Set external waveform to ON.
CONF:EXT:WAV 0 Set external waveform to OFF.
Query Syntax: CONFigure:EXTernal:WAVeform?
Return Parameters:<CRD>, OFF, ON [Unit = None]
Query Example: CONF:EXT:WAV?