2.7 DIRECT USB VIRTUAL COM
1663 supports “Direct” USB Virtual COM interface for memory mode. Use the provided
USB cable to connect 1663 to the USB port of PC. You may run HyperTerminal.exe on a
computer to view and capture the scanned data being transmitted to the computer. Refer
to
1.2.2 Memory Mode.
2.7.1 ACTIVATE USB VIRTUAL COM
Activate Direct USB
Virtual COM
Note: If using USB Virtual COM for the first time, install its driver from the CD-ROM.
Driver version 5.4 or later is required. Please remove older versions before
installing new ones!
2.7.2 AVTIVATE USB VIRTUAL COM_CDC
Activate Direct USB
Virtual COM_CDC
Note: If using USB Virtual COM for the first time, install its driver from the CD-ROM.
2.7.3 INTER-FUNCTION DELAY
By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254
in units of milliseconds, to match the computer response time of the keyboard interface.
Such delay time is inserted between every function code (0x01 ~ 0x1F) being
transmitted. The longer the delay time is, the slower the transmission speed will be.
Inter-Function
Delay… (*0~254)
1) Read the barcode above to specify the inter-function delay.
2) Read the “
Decimal Value” barcode on page 219 for the desired inter-function delay (in
milliseconds).
3) Read the “Validate” barcode on the same page to complete this setting.
To Next Page
Loading...
Need help?
General
