CipherLab 1663 User Manual (English)

To Next Page

To Previous Page

Update

Quick

Start

READ A SETUP BARCODE

CONFIGURE PARAMETERS

For most of the scanner parameters, only one read is required to set them to new values.

The scanner will respond with two beeps (low-high tone) when each parameter is set

successfully. Refer to

Create One-Scan Setup Barcodes.

But for a number of special parameters, multiple reads are required to complete the

setting. In this case, the scanner will respond with a short beep to indicate it needs to

read more setup barcodes. These special parameters may require reading one or more

setup barcodes, such as:

 Numeric barcodes, say, for keyboard type, inter-character delay, length qualification

 Hexadecimal barcodes, say, for character strings as prefix, suffix, etc.

 When “Bluetooth

HID” or “USB HID” is configured for interface, Key Type and Key

Status will then become applicable. Decide whether to change key status when

“Normal Key” is selected for Key Type.

To complete the configuration of these special parameters, it requires reading the

“Validate” barcode, and the scanner will respond with two beeps (low-high tone) to

indicate the input values are validated.

Need help?

Do you have a question about the CipherLab 1663 and is the answer not in the manual?

CipherLab 1663 Specifications

General

Scanning Technology	Laser
Scan Pattern	Single Line
Scan Rate	100 scans per second
Humidity	5% to 95% (non-condensing)
Connectivity Technology	Bluetooth
Interface	USB, RS232
Light Source	Laser Diode
Battery	Rechargeable Li-ion battery
Supported Symbologies	UPC, EAN, Code 39, Code 128, Interleaved 2 of 5, etc.
Power Supply	USB
Operating Temperature	0 to 50°C
Storage Temperature	-20°C to 60°C