For the scanner to read the serial number and beep -
#@RDSN<CR>
#@////<CR>
Note: (1) For USB Virtual COM, only configure the first scanner that connects to 3610.
To identify the scanner, send the serial command to have it respond with a beep.
(2) For Bluetooth
®
SPP, you can configure up to seven scanners at the same time.
3610 SETUP BARCODES & SERIAL COMMANDS
Normally, configure the 3610 dongle by having a connected scanner read 3610-related
setup barcodes.
1) Connect 3610 to the USB port of PC. You will need to install its driver first!
2) Refer to
3.1.1 Connect to 3610 for the target scanner to connect to 3610.
Read the “Set Connection” barcode first, and then the “Serial Number” barcod. Both
barcode labels can be located at the back of 3610.
3) Read the following barcodes in sequence to configure 3610.
Enter Setup
Update
For 3610-related setup barcodes, refer to the Serial Command table below. Note that for
the “Version” and “GetID” barcodes, you must run HyperTerminal.exe or any text editor
to receive or view the information.
If the output interface is USB Virtual COM, run HyperTerminal.exe on the host
computer to receive the information.
If the output interface is USB HID, run any text editor to receive the information.
(3610
To Next Page
Loading...
Need help?
General
