Auto Off after
0~254 min. (*10)
1) Read the barcode above to specify the time interval in minutes before the scanner
automatically turns off.
2) Read the “
Decimal Value” barcode on page 219. For example, read “1” and “5” for the
scanner to automatically turn off after being idle for 15 minutes.
3) Read the “Validate” barcode on the same page to complete this setting.
Note: Auto Power Off will not take effect when the scanner is in the configuration mode.
Power-
aving after
0~254 min. (*2)
1) Read the barcode above to specify the time interval in minutes before the scanner
enters low-speed mode.
2) Read the “
Decimal Value” barcode on page 219. For example, read “5” for the
scanner to enter low-speed mode after being idle for 5 minutes.
3) Read the “Validate” barcode on the same page to complete this setting.
Note: Power-Saving will not take effect when one of the following conditions is met:
(1) The scanner has already established a BT HID/SPP connection.
(2) The scanner is in the configuration mode.
(3) The scan mode is set to Test, Continuous or Alternate Mode.
To Next Page
Loading...
Need help?
General
