136
RS30 Mobile Computer Reference Manual
Code 32 Prefix Prefix character “A” to Code 32 barcodes.
“Convert to Code 32” must be enabled for this to function properly.
Disable
Verify Check Digit Selects whether to verify
the Modulo 43 check digit. If the
check digit is incorrect, the barcode will not be accepted.
Disable
Transmit Check Digit
Decide whether to include the check digit in the data to
transmit.
“Verify Check Digit” must be enabled.
Disable
Support Full ASCII
Selects whether to enable Code 39 Full ASCII decoding.
Characters are paired to encode the full ASCII character set.
Disable
Length option Sets the length of the Code 39 symbols to decode.
One Fixed length (Length 1)
Two Fixed lengths (Length 1>Length 2)
Max / Min Length (range: 0-55; Length 1<Length 2)
Any Length
Max / Min
Length
(4-55)
Code 93 Enable
Code 93 Switch to enable Code 93 decoding. Enable
Length option Sets the length of the Code 93 symbols to decode.
One Fixed length (Length 1)
Two Fixed lengths (Length 1>Length 2)
Max / Min Length (range: 0-55; Length 1<Length 2)
Any Length
Max / Min
Length
(4-55)
Code 128
Code 128 Switch to enable Code 128 decoding. Enable
GS1-128
GS1-128 Switch to enable GS1-128 decoding. Enable
ISBT 128
ISBT 128 Switch to enable ISBT 128 decoding. Enable
Discrete 25
Discrete 25 Switch to enable Discrete 2 of 5 decoding. Enable
Length option Sets the length of the Discrete 25 symbols to decode.
One Fixed length (Length 1)
Two Fixed lengths (Length 1>Length 2)
Max / Min Length (range: 0-55; Length 1<Length 2)
Any Length
Max / Min
Length
(4-55)
To Next Page
Loading...
