EasyManuals Logo

Cisco 7925G Deployment Guide

Cisco 7925G
150 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #125 background imageLoading...
Page #125 background image
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Deployment Guide
125
A pre-defined ringtone can be enabled by navigating to Settings > Phone Settings > Sound Settings > Ring Tone.
The Phone Designer application can be downloaded from the following location.
http://software.cisco.com/download/navigator.html?mdfid=278875240
Upgrading Firmware
There are two methods for upgrading the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G firmware, which is
either via wireless TFTP or the phone web interface.
Wireless TFTP
To upgrade the phone firmware, run the executable for Cisco Unified Communications Manager version 4.3 or install the COP
file for versions 5.1, 6.0, 6.1, 7.0, 7.1, 8.0, 8.5, 8.6, and later.
For information on how to install the COP file on CM versions 5.1 and later, refer to the Cisco Unified Communications
Manager Operating System Administrator Guide at this URL:
http://www.cisco.com/en/US/products/sw/voicesw/ps556/prod_maintenance_guides_list.html
During TFTP server download, the phone configuration file is parsed and the device load is identified. The phone
downloads the firmware files to flash if it is not running the specified image already.

Table of Contents

Other manuals for Cisco 7925G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7925G and is the answer not in the manual?

Cisco 7925G Specifications

General IconGeneral
Keypad number of keys12
Display diagonal2 \
Display resolution176 x 220 pixels
Call waitingYes
Lines quantity6 lines
Voice codecsG.711a, G.722, G.729a, iLBC
Security algorithms128-bit WEP, SSL/TLS, WPA
Supported network protocolsDHCP, TFTP, DNS, SCCP, SRST
Input voltage100 - 240 V
Dimensions (WxDxH)52 x 20 x 127 mm
Minimum system requirementsCisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency50/60 Hz
Storage temperature (T-T)-30 - 60 °C
Operating temperature (T-T)0 - 40 °C
Operating relative humidity (H-H)10 - 95 %
Product typeIP Phone
Product colorGray
SafetyUL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standardsIEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e
Weight and Dimensions IconWeight and Dimensions
Weight138 g

Related product manuals