RF Profiles
RF Profiles can be created to specify which frequency bands, data rates, RRM settings, etc. a group of access points should use.
RF Profiles are applied to an AP group once created. See the AP Groups section for more info on AP Group configuration.
When creating an RF Profile, the RF Profile Name and Radio Policy must be defined.
Select 802.11a or 802.11b/g for the Radio Policy.
On the 802.11 tab, configure the data rates as desired.
For 5 GHz, it is recommended to enable 12 Mbps as Mandatory and 18-54 Mbps as Supported and enable 11 Mbps as
Mandatory and 12-54 Mbps as Supported for 2.4 GHz; however some environments may require 6 Mbps to be enabled.
On the RRM tab, the Maximum Power Level Assignment and Minimum Power Level Assignment settings as well as other
TPC and Coverage Hole Detection settings can be configured.
To Next Page
Loading...
