Cisco 7925G Deployment Guide

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Deployment Guide
94
Note: If the TFTP IP is changed which is not included in the current Certificate Trust List (CTL) file, then TFTP will fail and
may prevent the phone from registering successfully to the Cisco Unified Communications Manager. The CTL file will need to
be erased manually in the Security Configuration menu from the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and
7926G.
Configuring Advanced Network Profile Settings
In the Advanced Network Profile settings, the minimum PHY rate can be adjusted. If 12 Mbps is not enabled in the wireless
LAN, then this parameter may need to be configured or enable 12 Mbps on the access point.
By limiting number of channels to be scanned, this can help reduce the time for access point discovery while passively scanning
DFS channels in 802.11a mode. This can also help preserve battery life.
If using this feature, then only disable those channels that are not used in the wireless LAN. If a channel is disabled that is
currently used by an access point, then the Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G might not associate
to the wireless LAN successfully.
If all channels that are used in the wireless LAN are disabled on the phone, then use one of these methods to browse to the
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G webpage:
• USB cable connected to the PC where full web access was previously enabled
• Re-enable all channels by using the factory default

Cisco 7925G Specifications

General

Keypad number of keys	12
Display diagonal	2 \
Display resolution	176 x 220 pixels
Call waiting	Yes
Lines quantity	6 lines
Voice codecs	G.711a, G.722, G.729a, iLBC
Security algorithms	128-bit WEP, SSL/TLS, WPA
Supported network protocols	DHCP, TFTP, DNS, SCCP, SRST
Input voltage	100 - 240 V
Dimensions (WxDxH)	52 x 20 x 127 mm
Minimum system requirements	Cisco Unified Communications Manager 4.1, 4.2, 4.3, 5.1, 6.0, 6.1, 7.0 + Cisco Unified Communications Manager Express 4.3 +
Input frequency	50/60 Hz
Storage temperature (T-T)	-30 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Product type	IP Phone
Product color	Gray
Safety	UL 60950, CSA 22.2 No.60950, EN 60950, IEC 60950, AS/NZS 60950, IEC 60529 (IP 54)
Certification	47 CFR 15 B ICES-003 B EN 55022 B AS/NZS CISPR 22 B CISPR 22 B VCCI B EN 61000-3-2 EN 61000-3-3 KN 22 EN 55024 EN 50082-1 EN 61000-6-1 EN 300386 EN 60601-1-2 KN
Compliance industry standards	IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.1X, IEEE 802.11e

Weight and Dimensions

Weight	138 g