Cisco 7925G - Call Control; Protocols

Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Deployment Guide
9
http://www.cisco.com/en/US/prod/collateral/netmgtsw/ps6491/ps6705/ps6535/data_sheet_c78-636705.html
• AirMagnet (Survey, WiFi Analyzer, VoFi Analyzer, Spectrum Analyzer)
http://www.airmagnet.com
Call Control
The Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G utilize Skinny Client Control Protocol (SCCP) for call
control with the following communications platforms.
7925G and 7925G-EX
• Cisco Unified Communications Manager (CUCM)
Minimum = 4.3
Recommended = 7.1(5), 8.5, 8.6, 9.1 and later
• Cisco Unified Communications Manager Express (CUCME)
Minimum = 4.3
Recommended = 8.6 and later
• Cisco Unified Survivable Remote Site Telephony (SRST)
Minimum = 4.3
Recommended = 8.6 and later
7926G
• Cisco Unified Communications Manager (CUCM)
Minimum = 7.1(5)
Recommended = 7.1(5), 8.5, 8.6, 9.1 and later
• Cisco Unified Communications Manager Express (CUCME)
Minimum = 8.6
Recommended = 8.6 and later
• Cisco Unified Survivable Remote Site Telephony (SRST)
Minimum = 8.6
Recommended = 8.6 and later
Device Support in Cisco Unified Communications Manager
Cisco Unified Communications Manager requires a device package to be installed or service release update in order to enable
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G device support.
Cisco Unified Communications Manager 5.1 or higher requires signed COP files.
Device packages for Cisco Unified Communications Manager are available at the following location.
http://software.cisco.com/download/navigator.html?mdfid=278875240
Protocols
Supported voice and wireless LAN protocols include the following: