Cisco ASR 5000 Series Administration Guide

CHAPTER 6
Verifying and Saving Your Configuration
This chapter describes how to save your system configuration.
•
Verifying the Configuration, page 97
•
Synchronizing File Systems, page 99
•
Saving the Configuration, page 99
Verifying the Configuration
You can use a number of commands to verify the configuration of your feature, service, or system. Many are
hierarchical in their implementation and some are specific to portions of or specific lines in the configuration
file.
Feature Configuration
In many configurations, you have to set and verify specific features. An example includes IP address pool
configuration. Using the example below, enter the listed commands to verify proper feature configuration.
Enter the show ip pool command to display the IP address pool configuration. The output from this command
should look similar to the sample shown below. In this example, all IP pools were configured in the isp1
context.
context : isp1:
+-----Type: (P) - Public (R) - Private
| (S) - Static (E) - Resource
|
|+----State: (G) - Good (D) - Pending Delete (R)-Resizing
||
||++--Priority: 0..10 (Highest (0) .. Lowest (10))
||||
||||+-Busyout: (B) - Busyout configured
||||||
vvvvvv Pool Name Start Address Mask/End Address Used Avail
----- --------------------- -------------- --------------- ----------------
PG00 ipsec 12.12.12.0 255.255.255.0 0 254
PG00 pool1 10.10.0.0 255.255.0.0 0 65534
SG00 vpnpool 192.168.1.250 92.168.1.254 0 5
Total Pool Count: 5
ASR 5500 System Administration Guide, StarOS Release 21.4
97

Cisco ASR 5000 Series Specifications

General

Brand	Cisco
Model	ASR 5000 Series
Category	Network Router
Language	English