EasyManuals Logo
Home>Cisco>Network Router>ASR 5000 Series

Cisco ASR 5000 Series Administration Guide

Cisco ASR 5000 Series
508 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #144 background imageLoading...
Page #144 background image
done, they could then "demote" the privileges of all the other users, thereby locking the proper administrators
out of the system.
The starLocalUserPrivilegeChanged trap indicates that a local user's privilege level has been changed.
User Access to Operating System Shell
The starOsShellAccessed trap indicates that a user has accessed the operating system shell.
Test-Commands
Users with Security Administrator or Administrator privilege can enable the display of previously hidden
test-commands. The CLI test-commands mode displays new command keywords for existing commands, as
well as new commands.
CLI test-commands are intended for diagnostic use only. Access to these commands is not required during
normal system operation. These commands are intended for use by Cisco TAC personnel only. Some of
these commands can slow system performance, drop subscribers, and/or render the system inoperable.
Caution
Enabling cli test-commands Mode
To enable access to test-commands, a Security Administrator must log into the Global Configuration mode
and enter cli hidden.
This command sequence is shown below.
[local]host_name# config
[local]host_name(config)# cli hidden
[local]host_name(config)#
By default cli hidden is disabled.
Low-level diagnostic and test commands/keywords will now be visible to a user with Administrator or
higher privilege. There is no visual indication on the CLI that the test-commands mode has been enabled.
Important
Enabling Password for Access to CLI-test commands
A Security Administrator can set a plain-text or encrypted password for access to CLI test commands. The
password value is stored in /flash along with the boot configuration information. The show configuration
and save configuration commands will never output this value in plain text.
The Global Configuration mode command tech-support test-commands [encrypted] password new_password
[ old-password old_password ] sets an encrypted or plain-text password for access to CLI test-commands.
ASR 5500 System Administration Guide, StarOS Release 21.4
112
System Security
User Access to Operating System Shell

Table of Contents

Other manuals for Cisco ASR 5000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco ASR 5000 Series and is the answer not in the manual?

Cisco ASR 5000 Series Specifications

General IconGeneral
BrandCisco
ModelASR 5000 Series
CategoryNetwork Router
LanguageEnglish

Related product manuals