Flow Control : Enabled
Link Aggregation Group : None
Untagged:
Logical ifIndex : 85262337
Operational State : Up, Active
Tagged VLAN: VID 10
Logical ifIndex : 285278210
VLAN Type : Standard
VLAN Priority : 0
Administrative State : Enabled
Operational State : Up, Active
Number of VLANs : 1
SFP Module : Present (10G Base-SR)
Notes:
•
Repeat this sequence as needed to verify additional ports.
•
Optional: Configure VLAN-subscriber associations. Refer to Configuring Subscriber VLAN Associations,
on page 302 for more information.
•
Refer to VLAN-Related CLI Commands , on page 303 for additional information.
•
Save your configuration as described in the Verifying and Saving Your Configuration chapter.
Configuring Subscriber VLAN Associations
Subscriber traffic can be routed to specific VLANs based on the configuration of their user profile. This
functionality provides a mechanism for routing all traffic from a subscriber over the specified VLAN. All
packets destined for the subscriber must also be sent using only IP addresses valid on the VLAN or they will
be dropped.
RADIUS Attributes Used
The following RADIUS attributes can be configured within subscriber profiles on the RADIUS server to
allow the association of a specific VLAN to the subscriber:
•
SN-Assigned-VLAN-ID: In the Starent VSA dictionary
•
SN1-Assigned-VLAN-ID: In the Starent VSA1 dictionary
Since the instructions for configuring subscriber profiles differ between RADIUS server applications, this
section only describes the individual attributes that can be added to the subscriber profile. Please refer to
the documentation that shipped with your RADIUS server for instructions on configuring subscribers.
Important
Configuring Local Subscriber Profiles
Use the configuration example below to configure VLAN associations within local subscriber profiles on the
system.
ASR 5500 System Administration Guide, StarOS Release 21.4
302
VLANs
Configuring Subscriber VLAN Associations
To Next Page
Loading...
Need help?
General
