•
ASR 5000 System Administration Guide
•
ASR 5500 System Administration Guide
•
Command Line Interface Reference Guide
•
ePDG Administration Guide
•
IPSec Reference Guide
•
SaMOG Administration Guide
•
VPC-SI System Administration Guide
Related Documentation
Revision History
Revision history details are not provided for features introduced before release 21.2.Important
ReleaseRevision Details
21.4PCAP Tracing support for MME S1-AP interface is added in this release.
21.2First introduced.
Feature Description
This feature enables the output of the monitor subscriber and monitor protocol commands to be captured
using the packet capture (PCAP) functionality. The output can be stored in a text file in a hard disk, and later
transferred to an external server through SFTP using a PUSH or PULL method. The text file can then be
converted to a pcap file using external tools such as text2pcap, or imported directly as PCAP using packet
analyzer tools such as wireshark.
PCAP trace and hexdump file collection can be enabled or disabled under the monitor protocol and monitor
subscriber commands. For more information, refer Enabling or Disabling Hexdump section of this chapter.
Configuring PCAP Trace
Enabling Multiple Instances of CDRMOD
Use the following configuration to enable multiple instances of CDRMOD (one per packet processing card):
config
cdr-multi-mode
end
Notes:
ASR 5500 System Administration Guide, StarOS Release 21.4
230
Packet Capture (PCAP) Trace
Feature Description
To Next Page
Loading...
Need help?
General
