To configure the system to provide access control list facility to subscribers:
Step 1
Apply the configured access control list by following the example configuration in Applying an ACL to Multiple
Subscriber via APNs, on page 263.
Step 2
Verify that ACL is applied properly on interface by following the steps in Verifying the ACL Configuration to APNs,
on page 264.
Step 3
Save your configuration to flash memory, an external memory device, and/or a network location using the Exec mode
save configuration command. For additional information refer to the Verifying and Saving Your Configuration chapter.
Verifying the ACL Configuration to APNs
To verify the ACL configuration:
Verify that your ACL lists were applied properly by entering the following command in Exec Mode:
show configuration context context_name
context_name is the name of the context containing the APN apn1 having default subscriber to which the ACL(s) was/were
applied.
The output of this command displays the configuration of the entire context. Examine the output for the commands
pertaining to interface configuration. The commands display the ACL(s) applied using this procedure.
configure
context context_name
ip access-list acl_name
deny host ip_address
deny ip any host ip_address
exit
ip access-group access_group_name
interface interface
ip address ip_address/mask
exit
subscriber default
exit
apn apn_name
ip access-group access_group_name in
ip access-group access_group_name out
end
ASR 5500 System Administration Guide, StarOS Release 21.4
264
Access Control Lists
Applying a Single ACL to Multiple Subscribers
To Next Page
Loading...
Need help?
General
