Cisco CATALYST 2960 - Booting a Specific Software Image; By default, the switch attempts to automatically boot up the system using information in the BOOT environment variable. If this variable is not set, the switch attempts to load and execute the first executable image it can by performing a recursive, depth-first search throughout the flash file system. In a depth-first search of a directory, each encountered subdirectory is completely searched before continuing the search in the original directory. However, you can specify a specific image to boot up.

Index
IN-2
Catalyst 2960 Switch Hardware Installation Guide
OL-7075-09
Cisco IP Phones, connecting to 1-12, 2-15
Cisco RPS
See RPS
CiscoView
1-22
class 1 laser warning 2-3, 3-2
CLI
accessing by using Express Setup
C-1
accessing through console port C-2
described 1-22
command-line interface
See CLI
compliance warning
2-4, 3-3
configuration examples, network 1-1
connecting
to 10/100/1000 ports
2-14
to console port B-4, C-3
to SFP modules 2-18 to 2-20
connecting to the console port B-4, C-3
connection procedures 2-14 to 2-20
connectors and cables
10/100/1000
B-1 to B-2
console B-4 to B-8
dual-purpose B-3
power (AC and RPS) 1-20
SC connectors B-3
SFP module ports B-3
console port
connecting to
C-3
described 1-21
specifications B-4 to B-8
crossover cable B-7
crossover cable, connecting to 1000BASE-T SFP module
ports
2-19
crossover cable pinout, four twisted-pair, 1000BASE-T
ports
B-7
D
DC power RPS 1-3
descriptions of switch models 1-1
desk-mounting 2-14, 3-6
device manager
described
1-22
to configure switch 2-21, 3-18
diagnosing problems 4-1
disconnecting device warning 2-3
dual-purpose ports
connectors and cables
B-3
described 1-13
LEDs 1-18
duplex, troubleshooting 4-4
duplex LED 1-16
E
electrical noise, avoiding 2-5, 3-4
Ethernet and fiber-optic cable troubleshooting 4-3
Ethernet cable warning
24- and 48-port switches
2-2
8-port switches 3-2
Ethernet ports warning 3-3
examples, network configuration 1-1
Express Setup, accessing CLI by using C-1
F
features 1-1
front panel
10/100/1000 ports
1-11
clearance 2-5, 3-4
description 1-4 to 1-17
dual-purpose ports 1-13
LEDs 1-14 to 1-17
SFP module ports 1-13