1-19
Catalyst 2960 Switch Hardware Installation Guide
OL-7075-09
Chapter 1 Product Overview
Rear Panel Description
Cable Guard for the Catalyst 2960 8-Port Switches
You can order an optional cable guard to secure cables to the front of the Catalyst 2960-8TC-L,
2960G-8TC-L, 2960-8TC-S, and 2960PD-8TT-L switches and prevent them from being accidentally
removed.
To order a cable guard, contact your Cisco representative using these part numbers:
• CBLGRD-C2960-8TC: Catalyst 2960-8TC-L, 2960-8TC-S, and 2960PD-8TT-L switches
• CBLGRD-C2960G-8TC: Cisco Catalyst 2960G-8TC switch
Rear Panel Description
• Internal Power Supply, page 1-20
• Cisco RPS, page 1-20
• Console Port, page 1-21
Depending on the Catalyst 2960 switch model, the switch can have an RJ-45 console port, a fan exhaust,
an RPS connector, and an AC power connector (see Figure 1-25 for an example of a Catalyst 2960 rear
panel).
Figure 1-25 Catalyst 2960 Switch Rear Panel
1 RJ-45 console port
1
1. The Catalyst 2960 8-port switches have the console port on the
front panel rather than on the rear panel.
3 RPS connector
2
2. These Catalyst 2960 switches do not have an RPS connector:
Catalyst 8-port switches, 2960-24-S, 2960-24TC-S, 2960-48TC-S,
and 2960-48TT-S switches.
2 Fan exhaust
3
3. The Catalyst 2960 8-port switches do not have a fan.
4 AC power connector
4
4. The Catalyst 2960PD-8TT-L switch does not have an AC internal
power supply.
To Next Page
Loading...
