2-13
Catalyst 2960 Switch Hardware Installation Guide
OL-7075-09
Chapter 2 Switch Installation (24- and 48-Port Switches)
Installing the Switch
Mounting the Switch on a Wall
For the best support of the switch and cables, make sure the switch is attached securely to wall studs or
to a firmly attached plywood mounting backboard. Mount the switch with the front panel facing up, as
shown in Figure 2-12.
Warning
To comply with safety regulations, mount the switches on a wall with the front panel facing up.
Statement 266
Warning
If a redundant power system (RPS) is not connected to the switch, install an RPS connector cover on
the back of the switch.
Statement 265
Figure 2-12 Mounting the Switch on a Wall
1 User-supplied screws
204621
SY
ST
R
P
S
M
A
S
TR
ST
A
T
D
UP
L
X
SP
EE
D
S
TA
C
K
MODE
1X
1X
11X
12X
1X
11X
12X
1X
11X
12X
1X
11X
12X
1
1
To Next Page
Loading...
