2-10
Catalyst 2960 Switch Hardware Installation Guide
OL-7075-09
Chapter 2 Switch Installation (24- and 48-Port Switches)
Installing the Switch
Mounting the Switch in a Rack
After the brackets are attached to the switch, use the four supplied number-12 Phillips machine screws
to securely attach the brackets to the rack, as shown in Figure 2-8.
Figure 2-8 Mounting the Catalyst 2960 Switch in a Rack
After the switch is mounted in the rack, do these tasks to complete the installation:
• Power on the switch. See the “Verifying Switch Operation” section on page 2-5.
• Connect to a 10/100 or 10/100/1000 port, and run Express Setup. See the Catalyst 2960 Switch
Getting Started Guide for instructions.
• Connect to the front-panel ports. See the “Connecting to the 10/100 and 10/100/1000 Ports” section
on page 2-14, the “Connecting to SFP Modules” section on page 2-18, and the “Connecting to a
Dual-Purpose Port” section on page 2-20 to complete the installation.
For configuration instructions about using the command-line interface (CLI) setup program, go to
Appendix C, “Configuring the Switch with the CLI-Based Setup Program.”
1 Phillips machine screws
SYST
RPS
STAT
DUPLX
SPEED
MODE
204618
1
To Next Page
Loading...
