Cisco CATALYST 2960 - Catalyst 2960-8 TC-S, Catalyst 2960-8 TC-L, and Catalyst 2960 G-8 TC -L Switches; Dual-Purpose Port; Figure

1-10
Catalyst 2960 Switch Hardware Installation Guide
OL-7075-09
Chapter 1 Product Overview
Front Panel Description
Catalyst 2960-8TC-S, Catalyst 2960-8TC-L, and Catalyst 2960G-8TC -L Switches
The console ports for the Catalyst 2960-8TC-S, Catalyst 2960-8TC-L, and Catalyst 2960G-8TC-L
switches (Figure 1-18 to Figure 1-20) are on the front panels. The switches also have a dual-purpose port
that can use either an RJ-45 connector or an SFP module, but not both at the same time. Use the software
to set the connector type for these ports.
For more information on the dual-purpose port, see the “Dual-Purpose Port” section on page 1-13. For
more information on the console port, see the “Console Port” section on page 1-21.
Figure 1-18 Catalyst 2960-8TC-S Switch Front Panel
Figure 1-19 Catalyst 2960-8TC-L Switch Front Panel
Figure 1-20 Catalyst 2960G-8TC-L Switch Front Panel
1 Console port 3 Dual-purpose port
2 10/100/100 ports
SYST
STAT
DPLX
SPD
MOD E
Catalyst 2960 SISeries
2
3
1
271432
1 Console port 3 Dual-purpose port
2 10/100/100 ports
2
3
Catalyst 2960 Series
CONSOLE
1x
SPD
DPLX
STAT
SYST
MODE
2x
3x 4x
5x 6x
7x
8x
1
1
204627
1 Console port 3 Dual-purpose port
2 10/100/1000 ports
2
3
Catalyst 2960G S eries
CONSOLE
1x
SPD
DPLX
STAT
SYST
MODE
2x
3x 4x
5x 6x
7x
1
1
204633