• If you are using a single Supervisor, you must install the Supervisor Card in the slot corresponding to
the Supervisor PIC.
In the Cisco cBR-8 router,
• Slot 4/1 for the Supervisor PIC corresponds to slot SUP0 for the Supervisor
Card.
• Slot 5/1 for the Supervisor PIC corresponds to slot SUP1 for the Supervisor
Card.
Note
Required Tools and Equipment
• ESD-preventive wrist strap
• Supervisor Card or blank card for the Supervisor
• 3/16" flat-blade torque screwdriver
Step 1 Loosen the captive screws on the appropriate slot using a 3/16" flat-blade torque screwdriver until the red bands are
visible on the captive screws.
Figure 50: Loosening the Captive Screws on the Supervisor Card
Step 2 Pull the spring-loaded ejectors on the card until they release and are perpendicular to the faceplate.
Step 3 Grasp the faceplate of the card with one hand and place your other hand under the card to support its weight.
Step 4 Carefully align the support rails on the card with the rails in the appropriate slot.
Step 5 Slide and push the card into the slot applying even pressure using both your hands until it mates with its midplane
connectors.
To prevent damage to the midplane connector, do not use excessive force when inserting the card into the slot.
Caution
Cisco Converged Broadband Routers Hardware Installation Guide
95
Installing the Supervisor in the Cisco cBR Chassis
Installing the Supervisor Card in the Cisco cBR Chassis
To Next Page
Loading...
Need help?
General
