Cisco cBR Series - Installing the Cisco Cbr in a Two-Post Rack

Figure 30: Flushing Against Mounting Rails
Step 6 Hold the chassis in position against the mounting rails and do the following:
a) Insert a bottom screw into the rack mount ear on each side and use a hand-held screwdriver to tighten the screw to
the rack rail.
b) Insert a top screw into each side rack mount bracket and tighten the screw to the rack rail.
Insert a minimum of four screws per bracket on both sides of the chassis.
Remove the chassis installation handle before installing the fourth screw.
Note
What to do next
• If necessary, remove the chassis installation brackets after ensuring that all screws are tightly secured to
the rack unit.
• Attach the cable management bracket.
Installing the Cisco cBR in a Two-Post Rack
You can install the Cisco cBR chassis in a two-post 19-inch (48.26 cm) rack either as a front mount or a
mid-mount.
Cisco Converged Broadband Routers Hardware Installation Guide
63
Installing the Cisco cBR Chassis
Installing the Cisco cBR in a Two-Post Rack