Cisco cBR Series Hardware Installation Guide

CHAPTER 5
Installing the Power System in the Cisco cBR
Chassis
• Installing the Power Cassette Module in the Cisco cBR Chassis, on page 77
• Installing the FPEM in the Cisco cBR Chassis, on page 79
• Installing the Power Module in the Cisco cBR Chassis, on page 81
• Connecting Power to the AC-Powered Cisco cBR Chassis, on page 84
• Connecting Power to the DC-Powered Cisco cBR Chassis, on page 85
Installing the Power Cassette Module in the Cisco cBR Chassis
The chassis ships with the Power Cassette Module installed. You may need to install the Power Cassette
Module to swap the power system of the chassis.
Before you begin
When you install the module, the chassis ground connection must always be made first and disconnected last.
Statement 1046
Warning
• Be aware of the weight and size of the equipment. Handle it with care.
Required Tools and Equipment
• 3/16" flat-blade torque screwdriver
• AC or DC Power Cassette Module
• T10 Torx torque screwdriver
Step 1 Loosen the two screws on the front power entry bezel using a 3/16" flat-blade torque screwdriver. Remove the front
power entry bezel from the chassis.
Cisco Converged Broadband Routers Hardware Installation Guide
77

Cisco cBR Series Specifications

General

Brand	Cisco
Model	cBR Series
Category	Network Router
Language	English