Cisco cBR Series Hardware Installation Guide

Monitoring the Digital Physical Interface Cards in the Cisco
cBR Chassis using LEDs
cBR CCAP Digital Through PIC
Table 42: Verifying the LEDs
DescriptionStatusLED
The card is not powered up.OffSTATUS
The card is operational.On
The specific link is down or the optical module
is absent.
Off10GE Link Status
The specific link is up.On
The card is operational and does not require
replacement.
OffREPLACE
The card requires replacement.On
cBR-8 2x100G Digital Physical Interface Card
Table 43: Verifying the LEDs
DescriptionStatusLED
The card is not powered up.OffSTATUS
The card is operational.On
The specific link is down or the optical module
is absent.
OffLink Status
Thespecific link is up. QSFP0 port is mapped
to LED 0,2,4,6 if it works in 10GE mode and
mapped to LED 0 if works in 100GE mode.
QSFP1 port is mapped to LED 1,3,5,7 if it
works in 10GE mode and mapped to LED 1 if
works in 100GE mode.
On
The card is operational and does not require
replacement.
OffREPLACE
The card requires replacement.On
Cisco Converged Broadband Routers Hardware Installation Guide
184
Monitoring the Interface Card in the Cisco cBR Chassis
Monitoring the Digital Physical Interface Cards in the Cisco cBR Chassis using LEDs

Cisco cBR Series Specifications

General

Category	Network Router
Modular Design	Yes
Operating System	Cisco IOS XE
Model Examples	cBR-8, cBR-4
Product Series	cBR Series
Purpose	Converged Broadband Router
DOCSIS Support	DOCSIS 3.1
Redundancy	Yes
Management	Cisco Prime
Product Family	cBR Series
Downstream Frequency Range	Up to 1.2 GHz
Upstream Frequency Range	Up to 204 MHz
Modulation Schemes	QAM
Power Supply	Redundant AC or DC power supplies
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Humidity	5 to 95% noncondensing