Cisco cBR Series - Using the NME Ports on the Supervisor PIC; Using the Console Port on the Supervisor PIC

Using the NME Ports on the Supervisor PIC
Before you begin
• Install the Supervisor PIC.
• Install the Supervisor Card.
Required Tools and Equipment
• RJ-45 cable
• Switch
Step 1 Connect one end of the RJ-45 cable to the NME port on the Supervisor PIC.
Figure 56: NME Port Connection on the Supervisor PIC
Step 2 Connect the other end of the RJ-45 cable to a switch.
What to do next
Route the RJ-45 cable through the Supervisor PIC cable management bracket and chassis-mounted fiber/cable
routing guide.
Using the Console Port on the Supervisor PIC
The console port provides local administrative access to the router and its command-line interface (CLI).
Before you begin
• Install the Supervisor PIC.
• Install the Supervisor Card.
Restrictions
• Each Supervisor PIC must have a console port connection when running a redundant configuration in
the chassis.
Required Tools and Equipment
Cisco Converged Broadband Routers Hardware Installation Guide
99
Installing the Supervisor in the Cisco cBR Chassis
Using the NME Ports on the Supervisor PIC