Cisco cBR Series Hardware Installation Guide

• 3/16" flat-blade screwdriver
Step 1 Loosen the two captive screws that secure the Supervisor PIC cable management bracket using a 3/16" flat-blade
screwdriver.
Figure 128: Removing the Supervisor PIC Cable Management Bracket
Supervisor PIC cable management bracket2Captive screws1
Step 2 Remove the Supervisor PIC cable management bracket.
What to do next
Replace the cable management bracket (if required).
Removing the Supervisor PIC from the Cisco cBR Chassis
Perform this procedure to remove the following PIC:
• Supervisor PIC
• Blank PIC for the Supervisor
Cisco Converged Broadband Routers Hardware Installation Guide
204
Maintaining the Supervisor in the Cisco cBR Chassis
Removing the Supervisor PIC from the Cisco cBR Chassis

Cisco cBR Series Specifications

General

Brand	Cisco
Model	cBR Series
Category	Network Router
Language	English