Cisco cBR Series Hardware Installation Guide

Figure 39: Installing the Power Cassette Module in the Chassis
Step 4 Insert the four #6-32 Torx-head screws into the mounting flanges. Tighten the screws using a T10 Torx torque screwdriver
with a torque of 8-10 in-lb (0.90-1.13Nm) to secure the module.
Step 5 Position the front power entry bezel on the chassis. Insert and tighten the two screws using a 3/16" flat-blade torque
screwdriver with a torque of 5-7 in-lb (0.56-0.79 Nm) to secure the bezel.
What to do next
• Install the FPEM.
• Install the Power Modules.
Installing the FPEM in the Cisco cBR Chassis
The chassis ships with the FPEM installed. You may need to install the FPEM to swap the power system of
the chassis. Use this procedure to install the following modules in the chassis:
• AC FPEM
• DC FPEM
Cisco Converged Broadband Routers Hardware Installation Guide
79
Installing the Power System in the Cisco cBR Chassis
Installing the FPEM in the Cisco cBR Chassis

Cisco cBR Series Specifications

General

Brand	Cisco
Model	cBR Series
Category	Network Router
Language	English