Figure 105: Closing the Spring-Loaded Ejectors on the Interface Line Card
Figure 106: Closed and Secured Spring-Loaded Ejectors on the Interface Line Card
Step 7 Tighten the two captive screws using a 3/16" flat-blade torque screwdriver with a torque of 10-12 lb-in (1.12-1.36 Nm)
to secure the card.
Cisco Converged Broadband Routers Hardware Installation Guide
149
Installing the Interface Line and PIC Cards
Installing the DOCSIS MAC/PHY Interface Line Card in the Cisco cBR Chassis
To Next Page
Loading...
