Figure 113: Closing the Spring-Loaded Ejectors on the Interface Line Card
Figure 114: Closed and Secured Spring-Loaded Ejectors on the Interface Line Card
Step 7 Tighten the two captive screws using a 3/16" flat-blade torque screwdriver with a torque of 10-12 lb-in (1.12-1.36 Nm)
to secure the card.
Cisco Converged Broadband Routers Hardware Installation Guide
156
Installing the Interface Line and PIC Cards
Installing the DOCSIS MAC Interface Line Card in the Cisco cBR Chassis
To Next Page
Loading...
