4035197 Rev C D9865 Satellite Receiver Installation and Operation Guide 4-55
Configuring IP Setup, Continued
Editing an IP Address
Proceed as follows to edit the Network IP Address:
1. From the IP Setup screen, press the yellow button (SetIPAddr).
2. The following table describes each of the options:
The Network Address, Prefix Mask, and Gateway Address should be changed
together, as a group. The following table shows the most commonly used
Subnet mask values to enter for a chosen IP address mask, which will depend on
the size of your network.
Note: Only Port 1 is available for this release.
Selection Options Description
IP Address 12 digits in length
(###.###.###.###)/
Sets the IP Address for its participation
in a Network environment.
Mask 8 to 32 Sets the Subnet Mask for its
participation in a Network
environment.
Gateway Address 12 digits in length
(###.###.###.###)
Sets the Network Gateway Address on
the Network, used to expose the
receiver to a WAN.
Mask Subnet Mask
8 255.0.0.0
16 255.255.0.0
24 255.255.255.0
To Next Page
Loading...
