Cisco PenTeleData 8800 Series Guide

DescriptionParameter
Provides the option to take the caller ID from PAID-RPID-FROM,
PAID-FROM, RPID-PAID-FROM, RPID-FROM, or FROM header.
Perform one of the following.
• In the phone configuration file with XML(cfg.xml), enter a string
in this format:
<Caller_ID_Header
ua="na">PAID-RPID-FROM</Caller_ID_Header>
• In the phone web page, select an option.
Allowed values: PAID-RPID-FROM, AID-FROM, RPID-PAID-FROM,
RPID-FROM, and FROM
Default: PAID-RPID-FROM
Caller ID Header
Controls whether to hold call leg with transfer target before sending
REFER to the transferee when initiating a fully-attended call transfer
(where the transfer target has answered).
Perform one of the following.
• In the phone configuration file with XML(cfg.xml), enter a string
in this format:
<Hold_Target_Before_Refer
ua="na">No</Hold_Target_Before_Refer>
• In the phone web page, select Yes or No.
Default: No
Hold Target Before Refer
When enabled and the Notify message body is too big causing
fragmentation, the Notify message xml dialog is simplified; Session
Description Protocol (SDP) is not included in the dialog xml content.
Perform one of the following.
• In the phone configuration file with XML(cfg.xml), enter a string
in this format:
<Dialog_SDP_Enable ua="na">No</Dialog_SDP_Enable>
• In the phone web page, select Yes or No.
Allowed values: Yes or No
Default: No
Dialog SDP Enable
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
346
Cisco IP Phone Installation
SIP Parameters

Cisco PenTeleData 8800 Series Specifications

General

Brand	Cisco
Model	PenTeleData 8800 Series
Category	IP Phone
Language	English