Cisco PenTeleData 8800 Series Guide

DescriptionParameter
If set to Yes, as a transferee, the phone will send a
NOTIFY with Event:Refer to the transferor for any
1xx response returned by the transfer target, on the
transfer call leg.
If set to No, the phone will only send a NOTIFY for
final responses (200 and higher).
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Ntfy_Refer_On_1xx-To-Inv_1_
ua="na">Yes</Ntfy_Refer_On_1xx-To-Inv_1_>
• In the phone web page, select Yes to enable this
feature.
Allowed values: Yes|No
Default: Yes
Ntfy Refer On 1xx-To-Inv
Configure G.729 Annex B settings.
Perform one of the following:
• In the phone configuration file with
XML(cfg.xml), enter a string in this format:
<Set_G729_annexb_1_
ua="na">Yes</Set_G729_annexb_1_>
• In the phone web page, select Yes to enable this
feature.
Allowed values: None|No|Yes|Follow silence supp
setting
Default: Yes
Set G729 annexb
Cisco IP Phone 8800 Series Multiplatform Phone Administration Guide for Release 11.3(1) and Later
372
Cisco IP Phone Installation
Parameters for SIP Settings on Extensions

Cisco PenTeleData 8800 Series Specifications

General

Brand	Cisco
Model	PenTeleData 8800 Series
Category	IP Phone
Language	English