11
Figure 1: Login Screen
If you can't connect
If the Dual-Band Wireless-N VPN Router does not respond, check the following:
• The Dual-Band Wireless-N VPN Router is properly installed, LAN connection
is OK, and it is powered ON. You can test the connection by using the "Ping"
command:
• Open the MS-DOS window or command prompt window.
• Enter the command:
ping 192.168.1.1
If no response is received, either the connection is not working, or your
PC's IP address is not compatible with the Dual-Band Wireless-N VPN
Router's IP Address. (See next item.)
• If your PC is using a fixed IP Address, its IP Address must be within the range
192.168.1.2 to 192.168.1.254 to be compatible with the Dual-Band Wireless-N
VPN Router's default IP Address of 192.168.1.1. Also, the Network Mask must
be set to 255.255.255.0. See Chapter 4 - PC Configuration for details on
checking your PC's TCP/IP settings.
• Ensure that your PC and the Dual-Band Wireless-N VPN Router are on the
same network segment. (If you don't have a router, this must be the case.)
• Ensure you are using the wired LAN interface. The Wireless interface can only
be used if its configuration matches your PC's wireless settings.
To Next Page
Loading...
