39
Wireless - Connection Control
This screen allows you to configure the Connection Control List to either permit or block
specific wireless client devices connecting to (associating with) the Wireless Router.
Figure 23: Connection Control
Data - Connection Control
Select SSID
Select the desired SSID from the drop-down list.
Enabled/Disabled
Enable or disable wireless connection control. The default is
Disabled.
Connection Control
There are two ways to control the connection (association) of
wireless client devices. You can either prevent specific devices
from connecting to the Wireless Router, or you can allow only
specific client devices to connect to the Wireless Router. The client
devices are specified by their MAC addresses. The default is to
allow only specific client devices.
Wireless Client List
Instead of manually entering the MAC addresses of each client, the
Wireless Router provides a convenient way to select a specific
client device from the client association table. Click this button and
a window appears to let you select a MAC address from the table.
The selected MAC address will be entered into the Connection
Control List.
MAC (01~20)
Enter the MAC addresses of the wireless client devices you want to
control.
To Next Page
Loading...
Need help?
General
