28
Setup - IP Mode Screen
You can either define your Router’s time manually or automatically through Time Server.
Figure 14: IP Mode Screen
Data - IP Mode Screen
IP Mode
IPv4 Only
This option utilizes IPv4 on the Internet and local network.
Dual-Stack IP
This option utilizes IPv4 over the Internet and IPV4 and IPv6 on the
local network. Then select how the IPv6 hosts will connect to the
Internet:
• NAPT-PT - This allows an IPv6-only host on your LAN to
connect to IPv4-only hosts on the WAN using address translation
and protocol-translation (per RFC2766).
• 6-4 Tunnel - This allows your IPv6 network to connect to other
IPv6 networks via tunnels through IPv4 (per RFC3056). The re-
mote router also needs to support 6to4.
6 to 4 Gateway
Access Control
Select the desired option to match your needs. Enter the related data in
the following fields if required.
• Disabled
• Permit following sites: Enter the IP addresses that you want to
permit in the following section.
• Block following sites: Enter the IP addresses that you want to
block in the following section.
To Next Page
Loading...
Need help?
General
