Cisco vEdge Series User Manual

State & DescriptionColor
• Blinking—The link is negotiated and active at a speed of 10M/100M, and
there is link activity.
• On steadily—The link is negotiated and active at a speed of 10M/100M,
but there is no link activity.
Yellow
• An SFP has been detected in the port.Alternating green and
yellow
• The port and link are not active.Off
Table 3 describes the LAN/WAN LED on the network ports.
Table 39:
State & DescriptionColor
• On steadily—The port is configured as a WAN
port.
• Off—The port is configured as a LAN port.
Green
Management Port
The management Ethernet port on a vEdge 1000 router uses an RJ-45 connector to connect to a management
device for out-of-band management.
The management port uses an autosensing RJ-45 connector to support a 10/100/1000Base-T connection. The
two LEDs on the port indicate link/activity on the port as well as the link speed status of the port. See
Management Port LEDs below.
Table 4 provides the pinout information for the RJ-45 connector for the management port.
Table 40:
DescriptionSignalPin
Transmit/receive data pair
1
TRP1+1
Transmit/receive data pair
1
TRP1-2
Transmit/receive data pair
2
TRP2+3
Transmit/receive data pair
3
TRP3+4
Transmit/receive data pair
3
TRP3-5
Hardware Installation Guide for vEdge Routers
122
vEdge 1000 Router
Ports and Connectors

Cisco vEdge Series Specifications

General

Connectivity Technology	Wired
Virtualization Support	Yes
High Availability	Yes
QoS Support	Yes
Product Type	Router
Data Link Protocol	Ethernet
Routing Protocols	BGP, OSPF
Interfaces	Gigabit Ethernet
Operating System	Cisco vEdge OS
Security	IPSec
Management	CLI