Wireless
Bridge
Cisco WAP571/E Administration Guide 102
5
NOTE The filter setting also applies to the MAC filtering list stored on the RADIUS
server, if one exists.
STEP 3 In the MAC Address field, enter the MAC address to allow or block and click Add.
The MAC address appears in the Stations List.
STEP 4 Continue entering MAC addresses until the list is complete, and then click Save.
The changes are saved to the Startup Configuration.
NOTE To remove a MAC address from the Stations List, select it and then click Remove.
NOTE After new settings are saved, the corresponding processes may be stopped and
restarted. When this happens, the WAP device may lose connectivity. We
recommend that you change WAP device settings when a loss of connectivity will
least affect your wireless clients.
Configuring MAC Authentication on the RADIUS Server
If one or more VAPs are configured to use a MAC filter stored on a RADIUS
authentication server, you must configure the station list on the RADIUS server. The
format for the list is described in this table:
Bridge
This section describes the two types of bridges. It includes the following topics:
WDS Bridge
RADIUS Server
Attribute
Description Value
User-Name (1) MAC address of the client station. Valid Ethernet MAC
address.
User-Password (2) A fixed global password used to
look up a client MAC entry.
NOPASSWORD
To Next Page
Loading...
Need help?
General
