Status and Statistics
WorkGroup Bridge Transmit/Receive
Cisco WAP571/E Administration Guide 24
2
WorkGroup Bridge Transmit/Receive
The WorkGroup Bridge Transmit/Receive page shows packet and byte counts for
traffic between stations on a WorkGroup Bridge. For information on configuring
WorkGroup Bridges, see Workgroup Bridge.
To show the WorkGroup Bridge Transmit/Receive page, select Status and
Statistics > WorkGroup Bridge in the navigation pane.
Each network interface that is configured as a WorkGroup Bridge interface shows
these fields:
• Network Interface—Name of the Ethernet or VAP interface. WLAN0
represents radio 1 and WLAN1 represents radio 2.
• Status and Statistics—Whether the interface is disconnected or is
administratively configured as up or down.
• VLAN ID—Virtual LAN (VLAN) ID. You can use VLANs to establish multiple
internal and guest networks on the same WAP device. The VLAN ID is set on
the VAP tab.
• Name (SSID)—Wireless network name. Also known as the SSID, this
alphanumeric key uniquely identifies a wireless local area network. The
SSID is set on the VAP tab.
Additional information appears for the transmit and receive direction for each
WorkGroup Bridge interface:
• Total Packets—The total number of packets bridged between the wired
clients in the WorkGroup Bridge and the wireless network.
• Total Bytes—The total number of bytes bridged between the wired clients
in the WorkGroup Bridge and the wireless network.
You can click Refresh to refresh the screen and show the most current information.
Associated Clients
You can use the Associated Clients page to view the client stations associated
with a particular access point.
To show the Associated Clients page, select Status and Statistics > Associated
Clients.
To Next Page
Loading...
Need help?
General
