4
Cisco WAP571/E Administration Guide 63
LAN
This section describes how to configure the port, VLAN, IPv4, and IPv6 settings of
the WAP device.
It includes these topics:
• Port Settings
• VLAN Configuration
• IPv4 Setting
• IPv6 Setting
• IPv6 Tunnel
• LLDP
Port Settings
Use the Port Settings page to view and configure the settings for the port that
physically connects the WAP device to a local area network.
To configure the port settings:
STEP 1 Select LAN > Port Settings.
The Port Settings Table includes the following status and configurations for two
Interfaces (Eth0 to Eth1):
• Link Status—Shows the current port link status.
• Port Speed—In review mode, it shows the current port speed. In edit mode,
if Auto Negotiation is disabled, select a port speed such as 100 Mbps or 10
Mbps. 1000 Mbps speed is only supported through Auto-Negotiation
enabled).
To Next Page
Loading...
Need help?
General
