Cisco WAP100 Series Administration Guide

Wireless
Scheduler
Cisco WAP571/E Administration Guide 98
5
Adding Scheduler Profiles
You can create up to 16 scheduler profile names. By default, no profiles are
created.
To view Scheduler status and add a Scheduler profile:
STEP 1 Select Wireless > Scheduler in the navigation pane.
STEP 2 Ensure that the Administrative Mode is enabled. By default it is disabled.
The Scheduler Operational Status area indicates the current operation status of
the Scheduler:
• Status—The operational status of the Scheduler. The range is Enabled or
Disabled. The default is Disabled.
• Reason—The reason for the scheduler operational status. Possible values
are:
- IsActive—The scheduler is administratively enabled.
- Administrative Mode is disabled—Operational status is down because
global configuration is disabled.
- System Time is out dated—System time is not in sync.
STEP 3 To add a profile, enter a profile name in the Scheduler Profile Configuration text
box and click Add. The profile name can be up to 32 alphanumeric characters.
Configuring Scheduler Rules
You can configure up to 16 rules for a profile. Each rule specifies the start time, end
time and day (or days) of the week the radio or VAP can be operational. The rules
are periodic in nature and are repeated every week. A valid rule must contain all of
the parameters (days of the week, hour, and minute) for the start time and the end
time. Rules cannot conflict; for example, you can configure one rule to start on each
weekday and another to start on each weekend day, but you cannot configure one
rule to begin daily and another rule to begin on weekends.
To configure a rule for a profile:

Cisco WAP100 Series Specifications

General

Brand	Cisco
Model	WAP100 Series
Category	Wireless Access Point
Language	English