ACL
ACL Status
Cisco WAP571/E Administration Guide 143
9
To associate an ACL to an interface:
STEP 1 Select ACL > ACL Association.
STEP 2 In the Interface field, click the radio or Ethernet interface on which you want to
configure the ACL parameters.
STEP 3 Configure these parameters for the selected interface:
• ACL Type—Choose the type of ACL that is applied to traffic entering the
WAP device, which can be one of these options:
- IPv4—Examines the IPv4 packets that match the ACL rules.
- IPv6—Examines the IPv6 packets that match the ACL rules.
- MAC—Examines the Layer 2 frames that match the ACL rules.
- None—Does not examine the traffic entering the WAP device.
• ACL Name—Choose the name of the ACL applied to traffic entering the
WAP device.
When a packet or frame is received by the WAP device, the ACL rules are
checked for a match. The packet or frame is processed if it is permitted and
discarded if it is denied.
STEP 4 Click Save. The changes are saved to the Startup Configuration.
ACL Status
The ACL Status page shows the details for different types of ACL rules.
To view the ACL status, select ACL > ACL Status.
The following information is displayed:
• ACL Name—The name of the ACL.
• Interface Bound—The interface to which the ACL has been associated.
• Rule No.—The number of the rule that the ACL contains.
• Action—The action to be taken by the ACL.
• Match All—Shows whether or not the ACL rule matches all packets.
To Next Page
Loading...
Need help?
General
