Status and Statistics
Email Alert Status
Cisco WAP571/E Administration Guide 32
2
Email Alert Status
The Email Alert Status page provides information about the email alerts sent
based on the syslog messages generated in the WAP device. To view the Email
Alert Status page, select Status and Statistics > Email Alert Status in the
navigation pane.
• Email Alert Status—The Email Alert configured status. The status is either
Enabled or Disabled. The default is Disabled.
• Number of Emails Sent—The total number of emails sent. The range is an
unsigned integer of 32 bits. The default is 0.
• Number of Emails Failed—The total number of email failures. The range is
an unsigned integer of 32 bits. The default is 0.
• Time Last Email Sent—The day, date, and time when the last email was
sent.
You can click Refresh to show the most current information.
Log
The Log page shows a list of system events that generated a log entry, such as
login attempts and configuration changes. The log is cleared upon a reboot and
can be cleared by an administrator. Up to 512 events can be shown. Older entries
are removed from the list as needed to make room for new events.
To view the Log page, select Status and Statistics > Log in the navigation pane.
• Time Stamp—The system time when the event occurred.
• Severity—Whether the event is due to an error (err) or is informational (info).
• Service—The software component associated with the event.
• Description—A description of the event.
You can click Refresh to refresh the screen and show the most current information.
You can click Clear All to clear all entries from the log.
To Next Page
Loading...
Need help?
General
