LAN
IPv6 Setting
Cisco WAP571/E Administration Guide 66
4
• Connection Type—By default, the DHCP client on the WAP device
automatically broadcasts the requests for network information. If you want to
use a static IP address, you must disable the DHCP client and manually
configure the IP address and other network information.
Choose one of these options:
- DHCP—The WAP device acquires its IP address from a DHCP server on
the LAN.
- Static IP—Manually configure the IPv4 address. The IPv4 address
should be in a form similar to xxx.xxx.xxx.xxx (192.0.2.10).
• Static IP Address, Subnet Mask, and Default Gateway—If you want to assign
a static IP address, enter the IP information in these fields.
• Domain Name Servers—Select one of the following options:
- Dynamic—The WAP device acquires the DNS server addresses from a
DHCP server on the LAN.
- Manual—Manually configure one or more DNS server addresses. Enter
up to two IP addresses in the fields provided.
STEP 3 Click Save. The changes are saved to the Startup Configuration.
NOTE After new settings are saved, the corresponding processes may be stopped and
restarted. When this condition happens, the WAP device may lose connectivity. We
recommend that you change the WAP device settings when a loss of connectivity
will least affect your wireless clients.
IPv6 Setting
Use the IPv6 Setting page to configure the WAP device to use IPv6 address.
To configure IPv6 address settings:
STEP 1 Select LAN > IPv6 Setting.
STEP 2 Configure these parameters:
To Next Page
Loading...
Need help?
General
