Administration
HTTP/HTTPS Service
Cisco WAP571/E Administration Guide 44
3
STEP 3 Select Profile Name from the drop-down selection list for Associate Scheduler
LED Display. By default there is no profile associated to the LEDs. The drop-down
selection will show the configured Scheduler Profile Names as in Wireless >
Scheduler page.
When the LED is associated to a Scheduler Profile, this column shows the status
depending on the presence or absence of an active profile rule at that time of the
day.
STEP 4 Click Save. The changes are saved to the Startup Configuration.
HTTP/HTTPS Service
Use the HTTP/HTTPS Service page to enable and configure web-based
management connections. If HTTPS is used for secure management sessions, you
also use the HTTP/HTTPS Service page to manage the required SSL certificates.
Configuring HTTP and HTTPS Services
To configure HTTP and HTTP services:
STEP 1 Select Administration > HTTP/HTTPS Service in the navigation pane.
STEP 2 Configure these Global Settings:
• Maximum Sessions—The number of web sessions, including both HTTP
and HTTPS, that can be in use at the same time.
When a user logs on to the WAP device configuration utility, a session is
created. This session is maintained until the user logs off or the Session
Timeout expires. The range is from 1 to 10 sessions. The default is 5. If the
maximum number of sessions is reached, the next user who attempts to log
on to the configuration utility receives an error message about the session
limit.
• Session Timeout—The maximum amount of time, in minutes, an inactive
user remains logged on to the WAP device configuration utility. When the
configured timeout is reached, the user is automatically logged off. The
range is from 1 to 60 minutes. The default is 10 minutes.
STEP 3 Configure HTTP and HTTPS services:
To Next Page
Loading...
Need help?
General
